原廠為了方便安裝OMNI ,因可直接用粗牙鏍絲上去12cm風扇位置4角
冷排裝在風扇和水泵中間
但因此架構下在自動控速時風扇以800rpm 運作,水泵架會為風扇抽出風有少量影響,及影響雙風扇安裝.
因此我們可動一動手改動
改動時留意修好電線
免風扇打到電線
不想改風扇
笫2種改動
使用Y線連接水泵電源及風扇電源
未改
改了,不使用電子控速,改用由主板PWM 控制,原廠電子控速是傾向靜音模式
笫3種
2 x 12cm
以上改動及作抽出或抽入溫度相差頗遠
跟個人需要作決定吧
檢查所有部份便可上機了
修改圖一
鏍絲圖
原装的,
570在預設下, 温度分別為最低46 最高79 扇速 56%
跑上850時脈, 温度分別為最低47 最高69 扇速 69%
Omni 更改后
570在預設下, 温度分別為最低37 最高57
跑上850時脈, 温度分別為最低37 最高59
本站文章除註明轉載外,均為本站原創編譯
轉載請註明:文章轉載自:TechOrz 囧科技 [http://www.techorz.com/]
本文標題:水冷系列 - CoolIt OMNI 改裝圖解
本文網址:https://www.techorz.com/hardware/coolit-omni-mod/
Be careful when doing this, I have 2 of these for my 580 SLI setup, I tried moving the 120cm fan from omni to the top (push) while adding a cooler master xtraflo (pull) configuration as this blog directed, I found the tube leading from the pump into the radiator fitting a bit tight, not sure how this will play out for the longevity of the fittings, proceed with caution is just my 2cents, don’t want coolant spashing on your gear 🙂
Cheers for a rocking product, my GTX580 SLI were 56-58 (bottom) and 61-62 (top) idle, 84-86 (bottom), 91-93 (top) load with reference cooler, with Omni ALC, it’s 32-35 idle on both, while on load, it’s roughly 76-78 room temp 25c, turn off AC room temp 31-32c and it goes up to 82-85c.. Tested using Heaven Benchmark, Crysis Warhead and Crysis 2 stress test looped 99…